image51

Our ffl has arrived!

Contact us NOW to schedule your projects.


FEATURED CERAKOTE PROJECTS!  

All of our pricing for CERAKOTE is below!


 

Tight Tolerance Parts and Markings:

We do not coat sears, springs, bores/chambers or other tolerance critical or high-flex parts. In addition, we do not media blast scopes or other optics and, as a result, there will not be as good an adhesion of the Cerakote to those items.


TOLERANCE: For standard firearms applications it is often inadvisable to coat both pins and pin holes, as the resulting one (1) mil thickness of the coating when applied to rounded surfaces creates increase of two (2) mil to the part tolerance and four (4) mil (.004) when both hole and pin are coated. This is also applicable to auto-pistol slide and frame fit, such as on tight-fitting 1911’s. We typically plug or mask holes and pins and only coat the pin ends. However, we can coat pins and holes and then custom fit these parts after coating for an additional charge. We recommend hand fitting and lapping for 1911 pistol slides and frames as this will yield a precision fit and can help to tighten looser fitting slide/frame combos.


MARKINGS: For receivers, frames, slides, Picatinny rails which have painted on or lightly laser etched markings these markings will be lost during the surface preparation and coating unless they are machine engraved or stamped. If these markings are of great importance we can mask over them, but those areas in and immediately around the markings will not be coated and, as such, will not blend. Manufacturer’s serial numbers will be masked at no additional charge where needed or coated where possible. Some manufacturer model numbers, name etc which are laser engraved will be masked over. This is per BATFE (ATF) regulations. 

Please consult us for specific requirements.


**DISCLAIMER**  

**If you are disassembling the firearm yourself it must be accompanied by a full inventory list of parts. Also, please ensure that every pin, spring and screw is COMPLETELY disassembled.**

**It is in your best interest to tear down your firearm and bring it in COMPLETELY stripped** 

(all sights, pins, plates, doors, springs and detents)